Code for safe operation of laser cutting machine

1.Comply with the general cutting machine safe operation procedures. Start the laser in strict accordance with the laser startup procedure.

2. Operators must be trained, familiar with equipment structure, performance, master the operating system knowledge.

3. Wear protective equipment according to the regulations, and wear protective glasses in accordance with the regulations near the laser beam.

4. Do not process a material without knowing whether it can be laser irradiated or heated to avoid the potential hazards of smoke and vapour.

5. When the equipment is in operation, the operator shall not leave the post without permission or ask someone to wait for the tube. If it is really necessary to leave, the machine should stop or cut off the power switch.

6. Keep fire extinguishers within easy reach; When not processing to turn off the laser or optical brake; Do not place paper, cloth or other flammable materials near unguarded laser beams.

7. In the process of processing found abnormal, should immediately shut down, troubleshooting in time or report to the supervisor.

8. Keep the laser, the bed and the surrounding site clean, orderly, no oil, workpiece, plate, waste in accordance with the regulations of stacking.

9. When using gas cylinders, the welding wires should be avoided to avoid electric leakage accidents. The use and transportation of gas cylinders shall comply with the supervision regulations of gas cylinders. Do not let gas cylinders explode in the sun or near heat sources. When opening the bottle valve, the operator must stand at the side of the bottle nozzle.

10. Follow high pressure safety procedures during maintenance. Follow the rules and procedures for every 40 hours of operation or weekly maintenance, every 1000 hours of operation or every 6 months of maintenance.

11. After starting the machine, manually start the machine at a low speed in X and Y directions to check whether there is any abnormal situation.

12. After the input of the new work piece program, it should be first run, and check its operation.

13. When working, pay attention to observe the operation of the machine tool, so as to avoid the cutting machine out of the effective travel range or two collision caused by accident

                   

Fiber laser cutting machine I5

                   

++